Xantrex Technology XDC - Manual (Page 201)

S
C
P
I C
o
m
m
an
d
R
ef
er
en
ce
S
C
P
I C
om
m
an
d S
um
m
ar
y
R
ele
as
e 3
.0
1
99
Table B.1IEEE 488.2 Commands
Function SCPI Command Description Query
Clear Status *CLS
[:]STATus[]:CLEAr Clears the status data structures. N/A
Standard Event Status
Enable Query *ESE?
[:]STATus[]:STANdard:ENABle Query the Standard Event Status Enable
register settings. N/A
Standard Event Status
Enable *ESE
[:]STATus[]:STANdard:ENABle Set the Standard Event Status Enable
Restier bits. N/A
Standard Event Status
Register Query *ESR?
[:]STATus[]:STANDard[:EVENt]? Query Standard Event Status Register. N/A
Identification Query *IDN?
[:]SYSTem[]:IDENtify? Query identification string. (Manufacturer’s
information.) N/A
Individual Status Query *IST? Reads the current state of the IEEE 488.1
defined "ist" local message in the device N/A
Operation Complete
Command *OPC Causes the device to generate the operation
complete message in the Standard Event
Status register when all pending delected
device operations have finished N/A
Query Opertion Complete
Command *OPC? Place and ASCII character “1” into the
output queue when all pending operations
have been finished. See IEEE 488.2-1992
section 12.5.3. N/A
Option Identification
Query *OPT?
[:]SYSTem[]:OPTIon Identify reportable device options N/A
Parallel Poll Enable
Register Query *PRE? Query the Parallel Poll Enable Register
setting N/A
Parallel Poll Enable
Register Command *PRE Sets the Parallel Poll Enable Register bits.
See IEEE 488.2 section 11.6 for details. N/A
Query Power On Status
Clear *PSC?
[:]STATus[]:POSClear? Query Power-On Status Clear setting N/A
Power-On Status Clear *PSC
[:]STATus[]:POSClear Controls the automatic power-on clearing of
the Service Requect Enable Register,
Standard Event Status Enable Register,
Parallel Poll Enable Register and other
event enable registers.
Possible values are
0 (leave them alone) or 1 (clear them).
N/A
Recall *RCL
[:]SYSTem[]=RECall Restores the settings of unit from values
stored in memory. N/A
Reset *RST
[:]SYSTem[]:RESet Performs a device reset. Set the power
supply to a known state that is independent
of the use history of the device. N/A
Save User Settings *SAV
[:]SYSTem[]:SAVE[USER] Stores the current setting of the device in
local memory. Scope is same as *RST N/A