Xantrex Technology XDC - Manual (Page 160)

Remote Operation
SCPI Commands for Digital Interfaces
158 Operating Manual for XDC Series Power Supply
IEEE 488.2 Status and Event Commands
Clear Status Command
Clears all Event Registers, including the Status Byte, the Standard Event Status and
the Error Queue.
Command: *CLS
SCPI equivalent for multichannel use: STATus[]:CLEar
Standard Event Status Enable Register
The Event Summary Enable command determines which bits in the Standard Event
Status Register are summarized in the Event Summary Bit (ESB) of the Status Byte.
The Power-on Status Clear command determines if the Standard Event Status Enable
Register is cleared at power-on.
E.g.
Sending "*ESE 16" sets bit 4 of the Standard Event Status Enable Register. This will
cause the Event Summary bit (ESB) in the Status Byte to be set whenever the
Execution Error bit (bit 4) in the Standard Event Status Register gets set.
Command: *ESE , *ESE?
SCPI equivalent for multichannel use:
STATus[]:STANdard:ENABle
STATus[]:STANdard:ENABle?
Standard Event Status Register
The Standard Event Status Register query allows the user to determine the current
contents of the Standard Event Status Register. (See “Standard Event Status
Register” on page 153.) Reading this register clears it.
Command: *ESR?
SCPI equivalent for multichannel use:
STATus[]:STANdard[:EVENt]?