ZyXEL Communications NBG410W3G - Manual (Page 60)

Chapter 3 Wizard Setup
NBG410W3G Series User’s Guide
60
The wizard screen varies according to the type of encapsulation that you select in the
Encapsulation field.
3.2.1.1 Ethernet
For ISPs (such as Telstra) that send UDP heartbeat packets to verify that the customer is still
online, please create a WAN-to-WAN/ZyXEL Device firewall rule for those packets. Contact
your ISP to find the correct port number.
Choose Ethernet when the WAN port is used as a regular Ethernet port.
Figure 14 ISP Parameters: Ethernet Encapsulation
The following table describes the labels in this screen.
Table 9 ISP Parameters: Ethernet Encapsulation
LABEL DESCRIPTION
ISP Parameters
for Internet
Access
Encapsulation You must choose the Ethernet option when the WAN port is used as a regular
Ethernet. Otherwise, choose PPPoE or PPTP for a dial-up connection.
WAN IP Address
Assignment
IP Address
Assignment
Select Dynamic If your ISP did not assign you a fixed IP address. This is the
default selection.
Select Static If the ISP assigned a fixed IP address.
The fields below are available only when you select Static.
My WAN IP
Address
Enter your WAN IP address in this field.
My WAN IP
Subnet Mask
Enter the IP subnet mask in this field.