ZyXEL Communications NBG410W3G - Manual (Page 277)

Chapter 15 Remote Management
NBG410W3G Series User’s Guide
277
The following table describes the labels in this screen.
15.15 DNS
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and
vice versa. Refer to
Chapter 6 on page 111 for more information.
Click ADVANCED > REMOTE MGMT > DNS to change your ZyXEL Device’s DNS
settings. Use this screen to set from which IP address the ZyXEL Device will accept DNS
queries and on which interface it can send them your ZyXEL Device’s DNS settings.
Figure 177 ADVANCED > REMOTE MGMT > DNS
Table 81 ADVANCED > REMOTE MGMT > SNMP
LABEL DESCRIPTION
SNMP
Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click Apply to save your customized settings.
Reset Click Reset to begin configuring this screen afresh.