ZyXEL Communications NBG410W3G - Manual (Page 273)

Chapter 15 Remote Management
NBG410W3G Series User’s Guide
273
The following table describes the labels in this screen.
15.13 FTP
You can use FTP (File Transfer Protocol) to upload and download the ZyXEL Device’s
firmware and configuration files, please see the User’s Guide chapter on firmware and
configuration file maintenance for details. To use this feature, your computer must have an
FTP client.
To change your ZyXEL Device’s FTP settings, click ADVANCED > REMOTE MGMT >
FTP. The screen appears as shown. Use this screen to specify which interfaces allow FTP
access and from which IP address the access can come.
"
It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 174 ADVANCED > REMOTE MGMT > FTP
Table 78 ADVANCED > REMOTE MGMT > Telnet
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.