ZyXEL Communications NBG410W3G - Manual (Page 245)

Chapter 13 Static Route
NBG410W3G Series User’s Guide
245
The following table describes the labels in this screen.
13.2.1 IP Static Route Edit
Click the edit icon in the IP Static Route screen. The screen shown next appears. Use this
screen to configure the required information for a static route.
Figure 149 ADVANCED > STATIC ROUTE > IP Static Route > Edit
The following table describes the labels in this screen.
Table 73 ADVANCED > STATIC ROUTE > IP Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Name This is the name that describes or identifies this route.
Active This field shows whether this static route is active (Yes) or not (No).
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the ZyXEL Device’s interface. The gateway helps forward
packets to their destinations.
Modify Click the edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Table 74 ADVANCED > STATIC ROUTE > IP Static Route > Edit
LABEL DESCRIPTION
Route Name Enter the name of the IP static route. Leave this field blank to delete this static route.
Active This field allows you to activate/deactivate this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.