ZyXEL Communications NBG410W3G - Manual (Page 276)

Chapter 15 Remote Management
NBG410W3G Series User’s Guide
276
15.14.2 SNMP Traps
The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:
15.14.3 REMOTE MANAGEMENT: SNMP
To change your ZyXEL Device’s SNMP settings, click ADVANCED > REMOTE MGMT >
SNMP. The screen appears as shown.
Figure 176 ADVANCED > REMOTE MGMT > SNMP
Table 80 SNMP Traps
TRAP # TRAP NAME DESCRIPTION
0 coldStart (defined in RFC-1215) A trap is sent after booting (power on).
1 warmStart (defined in RFC-
1215)
A trap is sent after booting (software reboot).
4 authenticationFailure (defined in
RFC-1215)
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
6 whyReboot (defined in ZYXEL-
MIB)
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
6a For intentional reboot : A trap is sent with the message "System reboot by user!"
if reboot is done intentionally, (for example, download
new files, CI command "sys reboot", etc.).
6b For fatal error : A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.