MITSUBISHI ELECTRIC MELSERVO MR-J2S- A - Manual (Page 4)

A - 3
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a fault, injury, electric
shock, etc.
(1) Transportation and installation
CAUTION
Transport the products correctly according to their masses.
Stacking in excess of the specified number of products is not allowed.
Do not carry the servo motor by the cables, shaft or encoder.
Do not hold the front cover to transport the servo amplifier. The servo amplifier may drop.
Install the servo amplifier in a load-bearing place in accordance with the Instruction Manual.
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
The controller and servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls or other equipment.
Do not install or operate the servo amplifier and servo motor which has been damaged or has any parts
missing.
Provide adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the servo amplifier and servo motor.
Do not drop or strike servo amplifier or servo motor. Isolate from all impact loads.
When you keep or use it, please fulfill the following environmental conditions.
Conditions
Environment
Servo amplifier Servo motor
[ ] 0 to 55 (non-freezing) 0 to 40 (non-freezing) During
operation
[ ] 32 to 131 (non-freezing) 32 to 104 (non-freezing)
[ ] 20 to 65 (non-freezing) 15 to 70 (non-freezing)
Ambient
temperature
In storage
[ ] 4 to 149 (non-freezing) 5 to 158 (non-freezing)
During
operation
90%RH or less (non-condensing) 80%RH or less (non-condensing) Ambient
humidity
In storage 90%RH or less (non-condensing)
Ambience Indoors (no direct sunlight) Free from corrosive gas, flammable gas, oil mist, dust and dirt
Altitude Max. 1000m (3280 ft) above sea level
HC-KFS Series
HC-MFS Series
HC-UFS13 to 73
X Y : 49
HC-SFS81
HC-SFS52 to 152
HC-SFS53 to 153
HC-RFS Series
HC-UFS 72 152
X Y : 24.5
HC-SFS121 201
HC-SFS202 352
HC-SFS203 353
HC-UFS202 to 502
X : 24.5
Y : 49
HC-SFS301
HC-SFS502 to 702
X : 24.5
Y : 29.4
[m/s 2 ] 5.9 or less
HA-LFS11K2 to 22K2
X : 11.7
Y : 29.4
HC-KFS Series
HC-MFS Series
HC-UFS 13 to 73
X Y : 161
HC-SFS81
HC-SFS52 to 152
HC-SFS53 to 153
HC-RFS Series
HC-UFS 72 152
X Y : 80
HC-SFS121 201
HC-SFS202 352
HC-SFS203 353
HC-UFS202 to 502
X : 80
Y : 161
HC-SFS301
HC-SFS502 to 702
X : 80
Y : 96
(Note)
Vibration
[ft/s 2 ] 19.4 or less
HA-LFS11K2 to 22K2
X : 38
Y : 96
Note. Except the servo motor with reduction gear.