3 parameters, Special adjustment functions – MITSUBISHI ELECTRIC MELSERVO MR-J2S- A User Manual
Page 187
8 - 6
8. SPECIAL ADJUSTMENT FUNCTIONS
8.5.3 Parameters
When using the gain changing function, always set " 4 " in parameter No.2 (auto tuning) to choose
the manual mode of the gain adjustment modes. The gain changing function cannot be used in the auto
tuning mode.
Parameter
No.
Abbrevi
ation
Name
Unit
Description
6
PG1
Position control gain 1
rad/s
36
VG1
Speed control gain 1
rad/s
Position and speed gains of a model used to set the response
level to a command. Always valid.
34
GD2
Ratio of load inertia moment to
servo motor inertia moment
0.1
times
35
PG2
Position control gain 2
rad/s
37
VG2
Speed control gain 2
rad/s
38
VIC
Speed integral compensation
ms
Control parameters before changing
61
GD2B
Ratio of load inertia moment to
servo motor inertia moment 2
0.1
times
Used to set the ratio of load inertia moment to servo motor
inertia moment after changing.
62
PG2B
Position control gain 2 changing
ratio
%
Used to set the ratio (%) of the after-changing position
control gain 2 to position control gain 2.
63
VG2B
Speed control gain 2 changing
ratio
%
Used to set the ratio (%) of the after-changing speed control
gain 2 to speed control gain 2.
64
VICB
Speed integral compensation
changing ratio
%
Used to set the ratio (%) of the after-changing speed integral
compensation to speed integral compensation.
65
CDP
Gain changing selection
Used to select the changing condition.
66
CDS
Gain changing condition
kpps
pulse
r/min
Used to set the changing condition values.
67
CDT
Gain changing time constant
ms
You can set the filter time constant for a gain change at
changing.