beautypg.com

Options and auxiliary equipment – MITSUBISHI ELECTRIC MELSERVO MR-J2S- A User Manual

Page 271

background image

13 - 46

13. OPTIONS AND AUXILIARY EQUIPMENT

Noise transmission route

Suppression techniques

1) 2) 3)

When measuring instruments, receivers, sensors, etc. which handle weak signals and may
malfunction due to noise and/or their signal cables are contained in a control box together with the
servo amplifier or run near the servo amplifier, such devices may malfunction due to noises
transmitted through the air. The following techniques are required.
1. Provide maximum clearance between easily affected devices and the servo amplifier.
2. Provide maximum clearance between easily affected signal cables and the I/O cables of the servo

amplifier.

3. Avoid laying the power lines (Input cables of the servo amplifier) and signal cables side by side or

bundling them together.

4. Insert a line noise filter to the I/O cables or a radio noise filter on the input line.
5. Use shielded wires for signal and power cables or put cables in separate metal conduits.

4) 5) 6)

When the power lines and the signal cables are laid side by side or bundled together, magnetic
induction noise and static induction noise will be transmitted through the signal cables and
malfunction may occur. The following techniques are required.
1. Provide maximum clearance between easily affected devices and the servo amplifier.
2. Provide maximum clearance between easily affected signal cables and the I/O cables of the servo

amplifier.

3. Avoid laying the power lines (I/O cables of the servo amplifier) and signal cables side by side or

bundling them together.

4. Use shielded wires for signal and power cables or put the cables in separate metal conduits.

7)

When the power supply of peripheral devices is connected to the power supply of the servo
amplifier system, noises produced by the servo amplifier may be transmitted back through the
power supply cable and the devices may malfunction. The following techniques are required.
1. Insert the radio noise filter (FR-BIF) on the power cables (Input cables) of the servo amplifier.
2. Insert the line noise filter (FR-BSF01 FR-BLF) on the power cables of the servo amplifier.

8)

When the cables of peripheral devices are connected to the servo amplifier to make a closed loop
circuit, leakage current may flow to malfunction the peripheral devices. If so, malfunction may be
prevented by disconnecting the grounding cable of the peripheral device.

(2) Noise reduction products

(a) Data line filter

Noise can be prevented by installing a data line filter onto the encoder cable, etc.
For example, the ZCAT3035-1330 of TDK and the ESD-SR-25 of NEC Tokin make are available as
data line filters.
As a reference example, the impedance specifications of the ZCAT3035-1330 (TDK) are indicated
below.
This impedances are reference values and not guaranteed values.

Impedance[ ]

10 to 100MHz

100 to 500MHz

80

150

Outline drawing (ZCAT3035-1330)

[Unit: mm]([Unit: in.])

Loop for fixing the
cable band

Lot number

Product name

TDK

39 1(1.54 0.04)

34 1

(1.34 0.04)

13

1

(0.

51

0.

04)

30

1

(1.

18

0.

04)