Canon EOS R5 C VR Creator Kit with RF 5.2mm f/2.8 Dual Fisheye Lens - Manual (Page 132)

Cu s tom Picture S etting s
132
NOTES
• Depending on other menu settings, you may not be able to obtain the desired image effect even after
changing the custom picture settings.
[White Balance]
[R Gain], [B Gain] –50 to +50 (±0)
These settings adjust the amount of white balance throughout the whole image by changing the
intensity of red tones ([R gain]) and blue tones ([B Gain]).
[Color Correction]
[Select Area] [Off] , [Area A], [Area B], [Area A&B]
The camera detects areas with certain color characteristics (color phase, chroma, area and Y level)
and corrects them when recording. You can set the color correction for up to two different areas
(A and B) and apply the color correction to either one ([Area A] or [Area B]) or both of them ([Area
A&B]).
While color correction is activated, parts of the image that are not detected as having the
characteristics specified for area A or B will appear colorless on the screen or the image output from
the output terminals (except when adjusting the [Revision Level]/[Revision Phase] settings).
[Area A Setting Phase],
[Area B Setting Phase] 0 to 31 (0)
These settings determine the color phase of the area to be corrected (A or B, respectively).
[Area A Setting Chroma],
[Area B Setting Chroma],
[Area A Setting Area],
[Area B Setting Area],
[Area A Setting Y Level],
[Area B Setting Y Level] 0 to 31 (16)
These settings determine the following color characteristics of the area to be corrected (A or B,
respectively).
[Area A Setting Chroma], [Area B Setting Chroma]: Color saturation.
[Area A Setting Area], [Area B Setting Area]: Color range.
[Area A Setting Y Level], [Area B Setting Y Level]: Brightness.
[Area A Revision Level],
[Area B Revision Level] –50 to +50 (±0)
These settings adjust the amount of correction applied to the color saturation in the corrected area
(A or B, respectively).
[Area A Revision Phase],
[Area B Revision Phase] –18 to +18 (±0)
These settings adjust the amount of correction applied to the color phase in the corrected area
(A or B, respectively).
[Other Functions]
[Over 100%] [Through] , [Press], [Clip]
Determines how the camera handles video signals exceeding 100%. This setting is not available
when the gamma curve component of the [Gamma/Color Space] setting is set to one of the
[Canon Log 3], [PQ] or [HLG] options.
[Through]: Leave the signal unchanged.
[Press]: Compress a signal of up to 108% down to 100% levels.
[Clip]: Clip the signal at 100%.
Menu items Options / Additional information