Canon EOS R5 C VR Creator Kit with RF 5.2mm f/2.8 Dual Fisheye Lens - Manual (Page 117)

117
S pecial Recording Mode s
• About the time code when frame recording is activated:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode. The time code
advances by the number of frames recorded every time.
- If the time code running mode was set to [Free Run] or the camera was synchronized to an external time
code signal, the time code running mode will be changed automatically to [Rec Run] when frame recording
is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the TIME CODE terminal or HDMI OUT terminal.
Interval Recording Mode
Set the interval and number of frames in advance. Sound is not recorded in this mode.
You can also use direct touch control to perform this function (
A
56).
1 S elect > [
Æ
Recording/Media S etup] > [Recording Mode] > [Interval Recording].
• [INT STBY] appears at the top of the screen (with [INT] flashing).
2 S elect > [
Æ
Recording/Media S etup] > [Interval Rec: Time Interval] > De s ired option.
3 S elect > [
Æ
Recording/Media S etup] > [Interval Rec: Frame Rate] > De s ired option.
4 Pre ss the REC button to begin recording.
• The tally lamp illuminates in red.
• [INT STBY] changes to [INT
Ü
REC] while recording.
• The camera automatically records the set number of frames at the specified interval.
5 Pre ss the REC button again to s top recording.
• The tally lamp illuminates in green and [INT STBY] appears at the top of the screen (with [INT] flashing).
6 S elect > [
Æ
Recording/Media S etup] > [Recording Mode] > [Normal Recording] to s top interval
recording.
NOTES NOTES
• Interval recording cannot be used simultaneously with slow & fast motion recording, pre-recording, frame
recording or continuous recording.
• Interval recording cannot be used when the frame rate is set to 59.94i or 50.00i. When in use, interval
recording will end if the frame rate is set to 59.94i or 50.00i.
• The interval and the number of frames recorded cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• About the time code when interval recording is activated:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode. The time code
advances by the number of frames recorded every time.
- If the time code running mode was set to [Free Run] or the camera was synchronized to an external time
code signal, the time code running mode will be changed automatically to [Rec Run] when interval recording
is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the TIME CODE terminal or HDMI OUT terminal.