Canon EOS R5 C VR Creator Kit with RF 5.2mm f/2.8 Dual Fisheye Lens - Manual (Page 107)

107
Video S cope s
Video Scope s
The camera can display a simplified waveform monitor or a vectorscope to check your recordings. The selected
video scope is displayed on the screen and can be output to other monitoring devices as well.
Di s playing a Video Scope
1 S elect > [
A
A ss i s tance Function s ] > [WFM Function] > [Waveform Monitor] or
[Vector s cope].
2 S elect > [
A
A ss i s tance Function s ] > One of the [WFM:] s etting s > [On].
• You can also use direct touch control ( A 56) to turn the [Waveform Monitor]/[Vectorscope] setting on/off.
• By default, the video scope will appear on the right of the screen. Using the > [
A
Assistance
Functions] > [Waveform Settings] or [Vectorscope Settings] > [Position] settings, you can select where to
display it (left or right side).
NOTES NOTES
• The waveform monitor will not be affected even if a LUT is applied to the image, the range is changed or
anamorphic desqueeze is used on the selected video output or screen.
• The video scopes will also be displayed while adjusting a custom picture file's image settings (
A
126).
Changing the Waveform Monitor Setting s
1 S elect > [ A A ss i s tance Function s ] > [Waveform S etting s ] > [Type] > De s ired option.
• If you selected an option other than [Select Line], skip to step 4.
2 S elect > [ A A ss i s tance Function s ] > [Waveform S etting s ] > [ S elect Line].
3 Enter the Y coordinate of the red horizontal line to di s play u s ing the data entry s creen (
A
25).
• The available range of lines that can be selected depends on the vertical component of the resolution used.
For 4320: 0 to 4318 (in 2-line increments)
For 2160: 0 to 2158 (in 2-line increments)
For 1080: 0 to 1079 (in 1-line increments)
For 720: 0 to 719 (in 1-line increments)
4 S elect > [ A A ss i s tance Function s ] > [Waveform S etting s ] > [Vertical S cale for HDR] >
De s ired option.
• Select the Y axis (luminance) scale used when displaying the waveform monitor of an HDR image.
5 S elect > [ A A ss i s tance Function s ] > [Waveform S etting s ] > [Gain] > [1x] or [2x].
• If you selected [1x], the rest of the procedure is not necessary.
6 S elect > [ A A ss i s tance Function s ] > [Waveform S etting s ] > [Y Po s ition] > De s ired option.
• The display range of the waveform monitor’s Y axis will be reduced by half. Select the minimum luminance
value (in %) shown on the Y axis.
Option s for [Type]
[Line]: Sets the waveform monitor to line display mode.
[Line+Spot]: The waveform of the area in the red frame is displayed in red on top of the [Line] mode
waveform.
[Select Line]: The selected horizontal line (in red) will be displayed along with its waveform.
[RGB]: Shows 3 side-by-side waveforms in an RGB parade.
[YPbPr]: Shows 3 side-by-side waveforms in a YPbPr parade.