Yaskawa MP2000 Series: User's Manual for Motion Programming - Manual (Page 83)

6.2 Using Variables
6-11
6
Variables (Registers)
6.2.4 Output Variables (O Registers)
(1) Overview
These variables are used for output data and servo setting parameters.
(2) Description
O registers are designated as follows:
(a) Register Numbers of Output Data
Depends on the address specified in the module configuration definition.
(b) Register Numbers of Motion Setting Parameter
The number of controlled axes depends on the module type. The following indicates the number of controlled
axes for each module and the maximum number of modules.
* 1. The number of axes controlled by one built-in SVB or SVB-01 depends on the MECHATROLINK definitions.
* 2. With MP2100M and MP2500MD, an expansion rack is required to use optional modules (SVB-01, SVA-01,
and PO-01).
* 3. The maximum number of optional modules (SVB-01, SVA-01, and PO-01) that can be mounted on MP2100M,
MP2200, or MP2500MD with an expansion rack.
OW0000 to OW7FFF: Output data
OW8000 to OWFFFF: Motion setting parameter
Table 6.5 Number of Axes Controlled by One Module
Motion Module
Number of Axes
Controlled by One
Module
Max. Number of Modules That Can Be Mounted on One
Machine Controller
MP21
00
MP210
0M
MP22
00
MP23
00
MP23
00S
MP23
10
MP24
00
MP25
00(D)
MP250
0M
MP250
0MD
MP2000 Series
Built-in SVB
16 max. *1 1 1 − 1 1 1 1 1 1 1
MP2100M/MP2500M
SVB-01
16 max. *1 − 1 − − − − − − 1 1
Optional Module
SVB-01
16 max. *1
−
14
*2
*3
16
*3
2 1 3 − − −
14
*2
*3
Optional Module
SVA-01
2
Optional Module
PO-01
4