Yaskawa MP2000 Series: User's Manual for Motion Programming - Manual (Page 253)

8 Command Reference
8.9.9 Binary to BCD (BCD)
8-146
8.9.9 Binary to BCD (BCD)
(1) Overview
The Binary to BCD (BCD) command converts binary data to BCD data.
Only integer data can be used. If the binary data is 9999 or higher or is a negative value, a correct result cannot be
obtained.
(2) Format
Note: Example 1
Example 2
If the binary data is greater than 9999, a correct result cannot be obtained.
(3) Programming Examples
BCD command programming examples are shown below.
Motion Programs Sequence Programs
Applicable Applicable
MW00100 = BCD (1234);
A B
Item Description Usable Registers
A
BCD data
output
• All integer and double integer type registers (Excluding # and C registers)
• The above registers with subscript
• Subscript registers
B
Binary data
input
• All integer and double integer type registers (Excluding # and C registers)
• The above registers with subscript
• Subscript registers
• Constants
MW00101
Converted to
MW00100 2 3 4 1 4 D 2 0
(1234H) 1234 (decimal)
0 3 9 3 MW00101
Converted to
3 4 5 C MW00100
(C345H) 12345 (decimal)
INFO
Type
Motion Programs/
Sequence Programs
Ladder Programs
B − −
W MW00101=BCD(MW00100);
L ML00102=BCD(ML00100);
F − −
EXAMPLE