HEIDENHAIN TNC 410 - Manual (Page 75)

62 5 Programming: Tools
ú Parameter number for result?: Parameter number in
which the TNC stores the status of the measurement:
0.0:
Tool is within tolerance
1.0: Tool is worn (RTOL exceeded)
2.0: Tool is broken (RBREAK exceeded)
If you do not wish to use the result of measurement
within the program, answer the dialog prompt with
NO ENT.
ú Clearance height: Enter the position in the spindle axis
at which there is no danger of collision with the
workpiece or fixtures. The clearance height is
referenced to the active workpiece datum. If you enter
such a small clearance height that the tool tip would
lie below the level of the probe contact, the TNC
automatically positions the tool above the level of the
probe contact (safety zone from MP6540)
ú Cutter measurement 0=No / 1=Yes:
Choose whether or not the TNC is to measure the
individual teeth.
5.4 T
o
o
l
Measur
ement with the
T
T
1
2
0
T
ouc
h
Pr
obe