HEIDENHAIN TNC 410 - Manual (Page 250)

237 HEIDENHAIN TNC 410
11
.2
T
est
Run
Running a program test
ú Select the Test Run mode of operation.
ú Call the file manager with the PGM MGT key and
select the file you wish to test, or
ú Go to the program beginning: Select line “0” with the
GOTO key and confirm you entry with the ENT key.
The TNC then displays the following soft keys:
Function Soft key
Test the entire program
Test each program block individually
Show the blank form and test the entire program
Interrupt the test run
Running a program test up to a certain block
With the STOP AT N function the TNC does a test run up to the
block with block number N. If you have selected a screen layout
showing a graphic, the graphic will also be brought up to block N.
ú Go to the beginning of program in the Test Run mode of
operation.
ú To run a program test up to a specific block,
press the STOP AT N soft key.
ú Up to block number: Enter the number of the block at
which the test run should stop.
ú Program: If you wish to go into a program that you call
with CALL PGM, enter the name of the program
containing the block with the selected block number.
ú Repetitions: If N is located in a program section
repeat, enter the number of repeats that you want to
run.
ú To test a program section, press the START soft key.
The TNC will test the program up to the entered block.