HEIDENHAIN TNC 410 - Manual (Page 245)

11 Test Run and Program Run 232
1
1
.1 Gr
aphics
11.1 Graphics
In the Test Run mode of operation the TNC graphically simulates
the machining of the workpiece. Using soft keys, select whether
you desire:
■ Plan view
■ Projection in 3 planes
■ 3-D view
The TNC graphic depicts the workpiece as if it were being
machined with a cylindrical end mill.
The TNC will not show a graphic if
■ the current program has no valid blank form definition
■ no program is selected
A graphic simulation is not possible for program or
program sections that include rotary-axis traverse. In
such cases the TNC displays an error messages.
Overview of display modes
After you have selected the GRAPHICS or PROGRAM + GRAPHICS
screen layout in the Test Run operating mode, the TNC displays the
following soft keys:
Display mode Soft key
Plan view
Projection in 3 planes
3-D view