HEIDENHAIN TNC 410 - Manual (Page 50)

37 HEIDENHAIN TNC 410
Programming tool movements in HEIDENHAIN
conversational format
To program a block, initiate the dialog by pressing a function key. In
the screen headline, the TNC then asks you for all the information
necessary to program the desired function.
Dialog initiation in an example
Initiate the dialog.
Coordinates ?
<
10 Enter the target coordinate for the X axis.
<
5 2x Enter the target coordinate for the Y axis,
and go to the next question with ENT.
Radius comp.: RL/RR/no comp. ?
<
Enter “No radius compensation” and go to
the next question with ENT.
Feed rate ? F=
<
100
Enter a feed rate of 100 mm/min for this
path contour; go to the next question with
ENT.
Miscellaneous function M ?
<
3 Enter the miscellaneous function directly,
e.g M3 for ”spindle on,” or
<
enter miscellaneous functions that require
additional input values, e.g. M120: Press
M120 and enter the values.
<
Press the END key to end the dialog and
save the entered block.
The program blocks window will display the following line:
3 L X+10 Y+5 R0 F100 M3
Functions during the dialog Key
Ignore the dialog question
End the dialog immediately,
save the block
Abort the dialog and erase the block
4.3 Cr
eating and
W
riting Pr
ogr
ams