HEIDENHAIN TNC 410 - Manual (Page 308)

295 HEIDENHAIN TNC 410
15.4
TNC Er
ro
r Messag
es
15.4 TNC Error Messages
The TNC automatically generates error messages when it detects
problems such as
■ Incorrect data input
■ Logical errors in the program
■ Contour elements that are impossible to machine
■ Incorrect use of the touch probe system
Some of the more frequent TNC error messages are explained in
the following list.
An error message that contains a program block number was
caused by an error in the indicated block or in the preceding block.
To clear the TNC error message, first correct the error and then
press the CE key.
TNC error messages during programming
Further file entry impossible
Erase some old files to make room for new ones.
Entry value incorrect
■ Enter a correct label number.
■ Note the input limits.
Ext. in-/output not ready
■ Connect the data transfer cable.
■ Transfer cable is defective or not soldered properly.
■ Switch on the connected device (PC, printer).
■ The data transfer speeds (baud rates) are not identical.
Protected file!
Cancel edit protection if you wish to edit the file.
Label number already assigned
A given label number can only be entered once in a program.
Jump to label 0 not permitted
Do not program CALL LBL 0.