HEIDENHAIN TNC 410 - Manual (Page 309)

15 Tables and Overviews 296
15.4
TNC Er
ro
r Messag
es
TNC error messages during test run and program run
Axis double programmed
Each axis can have only one value for position coordinates.
Selected block not addressed
Before a test run or program run, you must enter GOTO 0.
Touch point inaccessible
■ Pre-position the 3-D touch probe to a position nearer the model.
■ The machine parameters that define the position of the TT touch
probe do not correspond to the actual position of the TT touch probe.
Arithmetical error
You have calculated with non-permissible values.
■ Define values within the range limits.
■ Choose probe positions for the 3-D touch probe that are farther
apart.
■ Enter a value other than 0 for the number of teeth in the tool table
when you are measuring the individual teeth with the TT touch probe.
■ Calibrate TCH PROBE 30 (calibrate TT) before measuring the tool
length or radius.
■ All calculations must be mathematically possible.
Path comp. wrongly ended
Do not cancel tool radius compensation in a block with a circular path.
Path comp. wrongly started
■ Use the same radius compensation before and after an RND and
CHF block.
■ Do not begin tool radius compensation in a block with a circular path.
CYCL DEF incomplete
■ Define the cycles with all data in the proper sequence.
■ Do not call the coordinate transformation cycles.
■ Define a cycle before calling it.
■ Enter a pecking depth other than 0.
Plane wrongly defined
■ Do not change the tool axis while a basic rotation is active.
■ Correctly define the main axes for circular arcs.
■ Define both main axes for CC.
Wrong axis programmed
■ Do not attempt to program locked axes.
■ Program a rectangular pocket or slot in the working plane.
■ Do not mirror rotary axes.
■ Enter a positive chamfer length.