HEIDENHAIN TNC 410 - Manual (Page 170)

157 HEIDENHAIN TNC 410
8.4 Cy
cles f
or Milling P
o
c
k
ets,
St
uds and Slots
16 L Z+100 R0 FMAX M6
17 TOOL CALL 2 Z S5000
18 L Z+10 R0 F5000
19 CYCL DEF 212 POCKET FINISHING
Q200=2
;SET-UP CLEARANCE
Q201=-10 ;DEPTH
Q206=150 ;FEED RATE FOR PLUNGING
Q202=5 ;PLUNGING DEPTH
Q207=500 ;FEED RATE FOR MILLING
Q203=+0 ;SURFACE COORDINATE
Q204=0 ;2. SET-UP CLEARANCE
Q216=+0 ;CENTER IN 1ST AXIS
Q217=+0 ;CENTER IN 2ND AXIS
Q218=25 ;1ST SIDE LENGTH
Q219=16 ;2ND SIDE LENGTH
Q220=4 ;CORNER RADIUS
Q221=0.5 ;ALLOWANCE IN 1ST AXIS
20 CYCL CALL PAT F5000 M3
21 L Z+100 R0 FMAX M2
22 END PGM TAKOM MM
Retract the tool, change the tool
Move tool to clearance height (enter a value for F)
Cycle definition for pocket finishing
Surface coordinate (0 must be entered here)
2nd set-up clearance (0 must be entered here)
Center of X axis (0 must be entered here)
Center of Y axis (0 must be entered here)
Cycle call in connection with point table MUSTPKT.PNT
Retract the tool, end of program
Point table MUSTPKT.PNT
MUSTPKT .PNT MM
NR X Y Z
0 +35 +30 +0
1 +65 +30 +0
2 +80 +50 +0
3 +50 +50 +0
4 +20 +50 +0
5 +35 +70 +0
6 +65 +70 +0
[END]