HEIDENHAIN TNC 410 - Manual (Page 318)

M Effect of M Function Effective at block start end Page
M00 Stop program run/Spindle STOP/Coolant OFF ■ 105
M01 Optional program run interruption ■ 246
M02 Stop program run/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1
■ 105
M03 Spindle ON clockwise ■
M04 Spindle ON counterclockwise ■
M05 Spindle STOP ■ 105
M06 Tool change/Stop program run (depending on machine parameter)/Spindle STOP ■ 105
M08 Coolant ON ■
M09 Coolant OFF ■ 105
M13 Spindle ON clockwise/Coolant ON ■
M14 Spindle ON counterclockwise/Coolant ON ■ 105
M30 Same function as M02 ■ 105
M89 Vacant miscellaneous function or ■
Cycle call, modally effective (depending on machine parameter) ■ 121
M90 Only in lag mode: Constant contouring speed at corners ■ 107
M91 Within the positioning block: Coordinates are referenced to machine datum ■ 105
M92 Within the positioning block: Coordinates are referenced to position defined
by machine tool builder, such as tool change position
■ 105
M93 Within the positioning block: Coordinates are referenced to current tool position.
Valid in blocks with R0, R+, R–
■
M94 Reduce display of rotary axis to value less than 360° ■ 117
M97 Machine small contour steps ■ 112
M98 Completely machine open contours ■ 113
M99 Blockwise cycle call ■ 121
M101 Automatic tool change with replacement tool if max. tool life has expired ■
M102 ResetM101 ■ 51
M103 Reduce feed rate during plunging to factor F (percentage) ■ 114
M109 Constant contouring speed at tool cutting edge on circular arcs
(increase and decrease feed rate) ■
M110 Constant contouring speed at tool cutting edge on circular arcs
(feed rate decrease only) ■
M111 Reset M109/M110 ■ 115
M112 Automatic insertion of rounding arcs at non-tangential straight-line transitions;
Enter tolerance T for contour deviation ■
M113 Reset M112 108
M120 Radius-compensated contour Look Ahead ■ 115
M124 Ignore points for calculating rounding arc with M112 ■ 110
M126 Shorter-path traverse of rotary axes ■
M127 Reset M126 ■ 117
Miscellaneous Functions