HEIDENHAIN TNC 410 - Manual (Page 300)

287 HEIDENHAIN TNC 410
Machining and program run
Cycle 17: Oriented spindle stop at beginning of cycle
MP7160
Oriented spindle stop: 0
No oriented spindle stop: 1
Effect of Cycle 11 SCALING FACTOR
MP7410
SCALING FACTOR effective in 3 axes: 0
SCALING FACTOR effective in the working plane only: 1
Tool data in programmable probe cycle TOUCH–PROBE 0
MP7411
Overwrite current tool data by the calibrated data from the 3-D touch
probe system: 0
Current tool data are retained: 1
Contour element connection mode for milling
MP7415.0
Insert rounding arc: 0
Insert third-degree polynomial (cubic spline, curve without sudden
change in velocity): 1
Insert fifth-degree polynomial (curve without sudden change in
acceleration): 2
Seventh-degree polynomial (curve without sudden change in
acceleration rate of change): 3
Settings for contour milling
MP7415.1
Do not smoothen the contours: +0
Smoothen the contours: +1
Do not smoothen the velocity profile if a short straight-line segment
lies between contour transitions: +0
Smoothen the velocity profile if a short straight-line segment lies
between contour transitions: +2
15.1 Gener
al User P
a
ra
met
ers