1 gener al user p a ra met ers – HEIDENHAIN TNC 410 User Manual
Page 296
283
HEIDENHAIN TNC 410
15.1 Gener
al User P
a
ra
met
ers
Configure tool table (To omit from the table: enter 0);
Column number in the tool table for
MP7266.0
Tool name – NAME: 0 to 22
MP7266.1
Tool length – L: 0 to 22
MP7266.2
Tool radius – R: 0 to 22
MP7266.3
Reserved
MP7266.4
Oversize length – DL: 0 to 22
MP7266.5
Oversize radius – DR: 0 to 22
MP7266.6
Reserved
MP7266.7
Tool locked – TL: 0 to 22
MP7266.8
Replacement tool – RT: 0 to 22
MP7266.9
Maximum tool life — TIME1: 0 to 22
MP7266.10
Maximum tool life for TOOL CALL — TIME2: 0 to 22
MP7266.11
Current tool life — CUR. TIME: 0 to 22
MP7266.12
Tool comment – DOC: 0 to 22
MP7266.13
Number of teeth – CUT.: 0 to 22
MP7266.14
Tolerance for wear detection in tool length – LTOL: 0 to 22
MP7266.15
Tolerance for wear detection in tool radius – RTOL: 0 to 22
MP7266.16
Cutting direction – DIRECT.: 0 to 22
MP7266.17
PLC status – PLC: 0 to 22
MP7266.18
Offset of the tool in the tool axis in addition to MP6530 _ TT:L-OFFS: 0 to 22
MP7266.19
Offset of the tool between stylus center and tool center — TT:R-OFFS: 0 to 22
MP7266.20
Tolerance for break detection in tool length — LBREAK.: 0 to 22
MP7266.21
Tolerance for break detection in tool radius — RBREAK: 0 to 22