HEIDENHAIN TNC 410 - Manual (Page 297)

15 Tables and Overviews 284
15.1 Gener
al User P
a
ra
met
ers
Configure pocket tables (to omit from table enter 0); Column number in the tool table for
MP7267.0
Tool number — T: 0 to 5
MP7267.1
Special tool — ST: 0 to 5
MP7267.2
Fixed pocket — F: 0 to 5
MP7267.3
Pocket locked — L: 0 to 5
MP7267.4
PLC status — PLC: 0 to 5
Manual Operation mode: Display of feed rate
MP7270
Display feed rate F only if an axis direction button is pressed: +0
Display feed rate F even if no axis direction button is pressed (feed
rate of the „slowest“ axis): +1
Spindle speed S and miscellaneous function M effective
after STOP: +0
Spindle speed S and miscellaneous function M no longer effective
after STOP: +2
Display of gear range
MP7274
Do not display current gear range:0
Display current gear range: 1
Decimal character
MP7280
The decimal character is a comma: 0
The decimal character is a point: 1
Position display in the tool axis
MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced to the tool face: 1