HEIDENHAIN TNC 410 - Manual (Page 251)

11 Test Run and Program Run 238
1
1
.3 Pr
ogr
am Run
11.3 Program run
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the Program Run, Single Block mode of operation you must start
each block separately by pressing the machine START button.
The following TNC functions can be used in the program run modes
of operation:
■ Interrupt program run
■ Start program run from a certain block
■ Optional Block Skip
■ Checking and changing Q parameters
■ Additional status display
To run a part program:
Preparation
1 Clamp the workpiece to the machine table.
2 Set the datum
3 Select the part program (status M).
You can adjust the feed rate and spindle speed with the
override knobs.
Program Run, Full Sequence
ú Start the part program with the machine START button.
Program Run, Single Block
ú Start each block of the part program individually with the machine
START button.