HEIDENHAIN TNC 410 - Manual (Page 282)

269 HEIDENHAIN TNC 410
14.3 Code Number
To enter the code number, press the soft key with the key symbol.
The TNC requires a code number for the following functions:
Function Code number
Selecting user parameters 123
Canceling program protection 86357
Operating hours counter for:
Control On
Program Run
Spindle On
857282
You can reset the individual times by pressing the ENT key (must
be enabled by machine parameter)
14.4 Setting the Data Interface
Press the soft key marked RS 232 SETUP to call a menu for setting
the data interfaces:
Setting the OPERATING MODE of the external
device
External device RS232 INTERFACE
HEIDENHAIN floppy disk unit
FE 401 and FE 401B
FE
Non-HEIDENHAIN devices such as EXT1, EXT2
tape punchers, PC without TNCremo
PC with HEIDENHAIN software FE
TNCremo
No data transfer; e.g. digitizing
without position value capture, or
working without an external device
NONE
Setting the BAUD RATE
You can set the BAUD-RATE (data transfer speed) from 110 to
115,200 baud. For each operating mode (FE, EXT1 etc.), the TNC
stores and individual BAUD RATE.
14.3 Ent
er
ing the Code Number;
14.4 Set
ting the D
ata Int
erf
ace