HEIDENHAIN TNC 410 - Manual (Page 312)

299 HEIDENHAIN TNC 410
TNC error messages during digitizing
Axis double programmed
Program two different axes for the coordinates of the starting point
(CONTOUR LINES cycle).
Start position incorrect
Program the starting point coordinates for the CONTOUR LINES cycle
within the RANGE.
Touch point inaccessible
■ The stylus must not be deflected before it reaches the RANGE.
■ The stylus must be deflected somewhere within the RANGE.
Range exceeded
Enter a RANGE that includes the entire 3-D surface to be scanned.
Faulty range data
■ Enter MIN coordinates that are smaller than their MAX coordinates.
■ Define the RANGE within the limits through software limit switches.
■ Define the range for the MEANDER and CONTOUR LINES cycles.
Rotation not permitted
Reset all coordinate transformations before digitizing.
Height axis not permitted here
Define the starting position coordinate (CONTOUR LINES cycle) in axes
different from the stylus axis.
Wrong axis programmed
■ Enter calibrated touch probe axis in the RANGE cycle.
■ Do not program the same axes twice in the RANGE cycle
Scaling factor not permitted
Reset all coordinate transformations before digitizing.
Mirroring not permitted
Reset all coordinate transformations before digitizing.
Stylus already in contact
Pre-position the stylus so that it cannot be deflected outside the
RANGE.
15.4
TNC Er
ror Messag
es