HEIDENHAIN TNC 410 - Manual (Page 302)

289 HEIDENHAIN TNC 410
Cycle 4 POCKET MILLING and Cycle 5 CIRCULAR POCKET MILLING: Overlap factor
MP7430
0.1 to 1.414
Behavior of M functions
MP7440
Program stop with M06: +0
No program stop with M06: +1
No cycle call with M89: +0
Cycle call with M89: +2
Program stop for M functions: +0
No program stop for M functions: +4
Feed rate in tool axis with M103 F..
Reduction not effective: +0
Feed rate in tool axis with M103 F..
Reduction effective: +16
Do not set axis-in-position marker for waiting time between two NC
blocks: +0
Set axis-in-position marker for waiting time between two NC blocks: +32
Maximum permissible angle of directional change for constant contouring speed (effective for corners with R0 and for
all inside corners).
This feature works both during operation with
servo lag as well as with velocity feedforward.
MP7460
0.000 to 179.999 [°]
Maximum contouring speed at a feed rate override setting of 100% in the program run modes
MP7470
0 to 99 999 [mm/min]
Datums from a datum table are referenced to the
MP7475
Workpiece datum: +0
Machine datum: +1
Electronic handwheels
Handwheel type
MP7640
Machine without handwheel: 0
Multiple handwheels with supplementary buttons:5
HR 410 portable handwheel with additional functions: 6
Handwheel functions
MP7641
Interpolation factor can be entered with the keyboard: +0
Define interpolation factor via PLC module:+1
Handwheel not active in the Programming and Editing mode: +0
Handwheel active in the Programming and Editing mode: +2
15.1 Gener
al User P
a
ra
met
ers