HEIDENHAIN TNC 410 - Manual (Page 247)

11 Test Run and Program Run 234
1
1
.1 Gr
aphics
3-D view
The workpiece is displayed in three dimensions, and can be rotated
about the vertical axis.
The workpiece is displayed in three dimensions, and can be rotated
about the vertical axis.
In the Test Run mode of operation you can isolate details for
magnification (see “Magnifying details”).
ú Press the soft key for 3-D view.
To rotate the 3-D view
Shift the soft-key row until the following soft keys appear:
Function Soft keys
Rotate the workpiece in 27° steps
about the vertical axis
Magnifying details
You can isolate a detail in the Test Run operating mode, when the 3-
D display mode is selected.
The graphic simulation must first have been stopped. A detail
magnification is always effective in all display modes.
Shift the soft-key row in the Test Run mode of operation until the
following soft keys appear:
Function Soft keys
Select the workpiece surface to be
trimmed: Press the soft key several times
Shift the sectional plane to reduce or
magnify the blank form
Select the isolated detail