Orion System VCC-X Controller - Manual (Page 91)

VCC-X Operator Interface SD
INDEX
91
R-S
Mod Heat Enable.........38
Occupied Active.........38
Override Active.........38
Pre-Heat.........38
Remote HVAC Mode.........27
Remote Signal Contact.........14,22
Remote Space Sensor Board Address.........27
Remote Voltage.........27
Reset Rate Interval Screen.........27
Reset Source.........27
Reset Voltage Signal.........61
Restore Setpoints.........84
Return Air.........26
Return Air Airfl ow Monitoring.........33
Return Air Bypass Control.........26,36
Return Air Bypass Damper Factor
Setpoint.........51
Return Air Bypass Damper Signal.........61
Return Air CFM.........60
Return Air Damper Signal.........61
Return Airfl ow Duct Size.........34
Return Air Relative Humidity
Percentage.........57
Return Air Temperature Sensor.........52
Return Air Temperature Sensor
Calibration.........52
Return Air Temperature Status.........56
Return Sensor Type.........28
Return Temperature & Slide Adjust.........56
Reverse Acting Building Pressure
Control.........32
Reverse Acting Control.........48
RH Setpoint - Indoor.........43
RSM #1-#4 Status Screen Index.........67
RSM #1 OAT Lockout.........66
RSM #2 OAT Lockout.........66
RSM #3 OAT Lockout.........66
RSM #4 OAT Lockout.........66
RSM Installed.........26
RSM Mod Cool Reset Position &
Deadband.........66
RSM Module Installed.........25
RSMV Compressor Settings Screens.........66
RSMV Confi guration Setpoints Screens
Index.........64
S
SAT Reset Source Screen.........27
SAT Sensor Calibration.........52
Schedule
Button.........10,16
Mode.........80
Override.........14,15,22,23
Time & Date.........11,17
Schedule Mode Status.........55
Schedule Number.........34
Scheduling, VCC-X Controller.........14,22
Screens
12 Relay E-BUS Relay Confi guration
Screens.........37
AHU Uses Schedule Number.........34
Airfl ow Station Type.........33
Analog Output Override.........81
Broadcast Building Pressure.........35
Broadcast Outdoor Air RH.........35
Broadcast to Boxes.........36
Building Pressure Broadcast.........35
Building Pressure Control.........31
Building Pressure Control Rate.........31
Building Pressure Control Rate Max
Adjust.........31
Building Pressure Deadband
Setpoint.........49
Building Pressure Sensor
Installed.........31
Building Pressure Setpoint.........48
Celsius.........25
CO
2
Altitude Setpoint.........48
CO
2
Sensor Calibration.........53
CO
2
Sensor Installed.........31
CO
2
Setpoints Min/Max.........48
Coil Temperature Setpoint.........43
Communications Screen.........12,18
Confi guration Screens.........24
Controlling Sensor High Alarm
Offset.........42
Controlling Sensor Low Alarm
Offset.........42
Control Outdoor Air CFM.........33
Cooldown SAT Setpoint.........51
Cool/Heat Stage Delays.........36
Cool Reset Source Setpoints -
High/Low Reset.........44
Cool Type.........29
Cool Type Screen.........29
Daylight Savings Adjustment.........35
Dehumidifi cation Control.........32
Dirty Filter Screen.........35
Economizer Control Loop Rate.........30
Economizer Control Type.........30
Economizer Enable Setpoint.........47
Economizer Enable Source.........30
Economizer in Unoccupied
Mode.........30
Economizer Maximum Position
if High CO
2
Level.........48
Economizer Minimum Damper
Position.........47
Economizer Overrides.........81
Economizer Voltage Output.........31
EM1 Relay Confi guration
Screens.........37
Emergency Shutdown.........35
Exhaust Airfl ow Duct Size.........34
Exhaust Airfl ow Monitoring.........34
Exhaust Fan Output.........32
Exhaust VFD Override.........82
Fahrenheit.........25
Fan Cycle Mode Screen.........28
Fan Proving Screen.........28
Fan Starting Delay Screen.........29
Fan Voltage Output.........28
Head Pressure Setpoints - Cooling and
Reheat.........47
Heat/Cool Changeover Delay.........36
Heat Reset Source Setpoints - High/
Low Reset.........45
Heat Type.........29
Heat Wheel Defrost Temperature
Setpoint.........50
High Alarm Offset.........42
Holiday Schedule.........15,23
Hood On HVAC Setpoints.........40
Hood On HVAC Setpoints - OAT Cool,
OAT Heat.........40
Humidity Control Sensor Type.........32
HVAC Mode Set By Remote
Contact.........27
HVAC Source.........26
Indoor RH Setpoint.........43
Initialization for Modular Service
Tool.........11,17
Loop Search Screen.........20
Low Alarm Offset.........42
Low Ambient Setpoint.........50
Maximum Economizer Position in
Heat Mode.........47
Mechanical Heat/Cool Alarm Delay
Screen.........30
MiniLink PD Confi guration.........79
Mod Cooling Override.........82
Mod Cool Proportional Window and
Time Period.........46
Mode Deadband.........41
Mod Heating Override.........81
Mod Heat Output Position in Off
Mode.........49
Mod Heat Proportional Window and
Time Period.........46
Modulating Heat Output Signal.........29
Monitor Outdoor Air Airfl ow.........33
Morning Cool-Down Type.........36
Morning Warm Up.........34
Morning Warm Up Max Length &
Target Setpoint.........50
OA Temp Broadcast.........35
OAT Lockouts - Comp Cool/Comp
Heat.........49
OAT Lockouts - Heat.........49
OAT Sensor Calibration.........52
Occupied HVAC Cool/Heat
Setpoints.........40
Outdoor Air Airfl ow
Monitoring.........33
Outdoor Air CFM Control.........33
Outdoor Air CFM Setpoint.........47
Outdoor Airfl ow Duct Size.........33
Outdoor Dewpoint Setpoint.........42