Orion System OE361-13 CommLink 5 - Manual

Form: ORION-OE361-13-CMLK5-01A
Page 1 of 1
Description
The OE361-13 CommLink 5 Communications
Interface allows computer access into the
Orion controls system and also provides
communications across multiple local com-
munications loops on the control system.
The CommLink 5 comes packaged in an at-
tractive beige colored plastic enclosure. The
CommLink 5 is powered by a small plug-in
transformer that is included. Locally, an op-
tional on-site personal computer with Prism II
software installed may be connected to the
CommLink 5 to provide direct access to sys-
tem control parameters. A USB cable (6 ft.
long) is provided with the CommLink 5 for
connection to your computer.
An optional OE415-02 IP Module Kit, when
installed and configured in the CommLink 5
communication interface, provides TCP IP
Internet and/or intranet connection for Ether-
net networked computer systems, allowing
them to communicate with your control sys-
tem. The OE415-02 IP Module Kit consists of
the IP Module and a 10 ft. long CAT5 Ether-
net crossover cable.
Using standard TCP/IP Protocol, with Watt-
Master’s Prism II software, you are able to
monitor and configure your controllers without
a modem or a direct connection from a PC.
Utilizing existing routers, proxies, or firewalls
allows a PC running Prism II to connect to a
controller in a remote accessible location or
building. Several IP connection profiles can
be created to facilitate monitoring several
CommLink 5’s with IP Module Kits installed
on individual sites.
Mounting
If an on-site computer is to be used for direct
connection and monitoring of the system, the
CommLink 5 should be located near the
computer terminal to monitor the system.
1.50
7.00 5.25
REAR VIEW
FRONT VIEW
R ( + )
S H L D
T ( -)
OE361-13 CommLink 5
Communication Interface
Technical Data OE361-13 CommLink 5 Communication Interface
Power 24 Volt AC *Ethernet Conn. RJ-45 Ethernet Port
Plug-in Transformer 120V to 24VAC (Included) Local Loop RS-485 – 9600 Baud
Power Consumption 14 VA Maximum Network Loop RS-485 –19,200 or 57,600 Baud
Operating Temperature 10
F to 140F Protocol HSI Open Protocol Token Passing
Operating Humidity 90% RH Non-Condensing Cabling Included (1) 6 Ft. Long USB Cable
Computer Conn. USB Version 1.1 or 2.0
Three Year Warranty WattMaster reserves the right to change specifications without notice
* This Port Is Only Used With The Optional OE415-02 IP Module Kit.