Rsmv configuration, Rsmv confi guration screens, Vcc-x operator interface sd – Orion System VCC-X Controller User Manual
Page 65: Modular service tool instructions, System manager sd instructions
VCC-X Operator Interface SD
RSMV CONFIGURATION
65
RSMV Confi guration Screens
Modular Service Tool Instructions
No matter what screen or menu you’re in, press
TION>
. The Unit Selection Screen will appear, shown below, request-
ing that you enter the unit ID number.
Enter Unit Address
Then Press Enter
Selected Unit #_1
Press Down
Enter
the correct unit ID number of the Controller that the RSMV
Module(s) are connected to and press
. Once communica-
tion is established, the *00* message will go away.
NOTE:
If the *00* remains, it indicates a communication
failure to the controller.
Then
press
<
>
. You will then see the Confi guration Selection
Screen below:
VCC-X CONFIGURATION
RSM CONFIGURATION
Select & Press Enter
Select RSM Confi guration and then press
. The following
screen will appear:
Select
one of the options and press
.
SETUP RSM STAGING
COMPRESSOR SETTINGS
System Manager SD Instructions
From any Main screen, press
. The screen below
will appear because this option requires passcode clearance. Only
a Level 2 passcode can change setpoints.
THIS ACTION REQUIRES
PASSCODE CLEARANCE
Enter Passcode: XXXX
If the correct passcode was entered, the Unit Selection Screen will
be displayed.
Enter Unit Address
Then Press Enter
Selected Unit #_1
Press Down
Enter
the correct unit ID number of the Controller that the RSMV
Module(s) are connected to and then press
. Once com-
munication is established, the *00* message will go away. Then
press
<
>
. press
. Once communication is established,
the *00* message will go away. Then
press
<
>
.
NOTE:
If the *00* remains, it indicates a communication
failure to the controller.
The following screen will be displayed:
Change Setpoints
Configure Unit
Save/Copy/Restore
Scroll down to the ‘Confi gure Unit’ option and press
VCC-X CONFIGURATION
RSM CONFIGURATION
Select & Press Enter
Select RSM Confi guration and then press
. The following
screen will appear:
SETUP RSM STAGING
COMPRESSOR SETTINGS
Select
one of the options and press
.
- VCB-X Controller VCB-X VCB-X Modular Service Tool VCM Controller Operator Interfaces SD VCM-X/RNE Controller VCC-X Modular System Manager SD Modular System Manager SD Quick Start VCM-X/RNE Controller Operator Interface SD SA E-BUS Controller VAV II Controller v.1 CAV II Controller v.1 MUA II Controller v.1 VAV II Controller v.2 CAV II Controller v.2 MUA II Controller v.2