Orion System VCC-X Controller - Manual (Page 83)

VCC-X Operator Interface SD
APPENDIX A - SAVE, LOAD, COPY SETPOINTS
83
Modular Service Tool Instructions
From any menu screen, press . The Unit Selec-
tion Screen will appear requesting that you enter the unit ID number.
Enter Unit Address
Then Press Enter
Selected Unit #_1
Press Down
Enter the network unit ID for the controller you want to save the
setpoints from. Example, ‘102’ for Loop 1 / Unit 2. Then press
. Once communication is established, the *00* message
will go away. After a brief pause, press <

> to get to the Balance
- Test Screen shown below.
Outputs Force
Para Blocks
Save/Copy/Restore
Scroll down to the ‘Save/Copy/Restore’ option and press .
This will take you to the Save Setpoints screen.
System Manager SD Instructions
From any Main screen, press . The screen below
will appear because this option requires passcode clearance. Only a
Level 2 passcode can change setpoints.
THIS ACTION REQUIRES
PASSCODE CLEARANCE
Enter Passcode: XXXX
If the correct passcode was entered, the Unit Selection Screen will
be displayed.
Enter Unit Address
Then Press Enter
Selected Unit #_1
Press Down
Enter the Unit ID of the controller you wish to save the setpoints
from and press
. Once communication is established, the
*00* message will go away. Then press <  > .
NOTE: If the *00* remains, it indicates a communication
failure to the controller.
The following screen will be displayed:
Change Setpoints
Configure Unit
Save/Copy/Restore
Scroll down to the ‘Save/Copy/Restore’ option and press .
This will take you to the Save Setpoints screen.
Save Setpoints - Network Mode
From the Save Setpoints Screen shown below:
Save Setpoints
Press Enter To Save
Press and a setpoint fi le will be saved to the SD card.
You will receive a message that the save was successful. This fi le
is specifi c to this controller on this loop.
Saving & Copying Setpoints