Adobe Premiere Elements 12 - Manual (Page 165)

Pinning
Phase
Antialiasing
To the top
Flare Center
Flare Brightness
Lens Type
Blend With Original
To the top
Hue
Lightness
Saturation
Options from a pop-up menu set the orientation of the wave.
Sets the starting point, in degrees, at which the wave cycle begins.
Options from a pop-up menu control the amount of blurring used to smooth the edges of the waves.
Generate
Lens Flare
Use the Lens Flare effect to simulate the refraction caused by shining a bright light into the camera lens.
Specifies a location for the center of the flare.
Specifies the percentage of brightness. Values can range from 0% to 300%.
Selects the type of lens to simulate.
Specifies the degree to which the effect will be blended with the source clip.
Image control
Black & White
The Black & White effect converts any color clip to grayscale. That is, colors appear as shades of gray. You cannot apply keyframes to this effect.
Color Balance (HLS)
The Color Balance (HLS) effect alters a clip’s levels of hue, lightness, and saturation.
Specifies the color scheme of the clip.
Specifies the brightness of the clip.
Specifies the intensity of the colors in the clip.
note: Setting the Saturation to -100 converts a movie to grayscale.
Color Balance (RGB)
The Color Balance effect changes colors in the clip by adjusting its RGB levels. Drag the Red, Green, and Blue sliders to adjust the level of each
color.
161