CIRCUTOR CVM-B Series - Manual (Page 211)

B- Protective cove version 2
To install, firstly remove the protective cover of the expansion connector located at the rear of
the unit. To do so:
a�- Remove the two fastening pins that secure the protective cover with a flat tip screwdriver,
figure 145 .
Protective cover
figure 145: Remove the two fastening pins�
b�- Remove the protective cover by inserting a flat tip screwdriver into the fixing slot and press
the cover upwards. ( figure 146)
figure 146: Remove the protective cover�
Connect the expansion module to the unit, figure 147 .
figure 147: Connect the expansion module�
211 Instruction Manual
CVM-B100 - CVM-B150