CIRCUTOR CVM-B Series - Manual (Page 145)

After selecting the output to configure, figure 129 , the following parameters can be configured:
 The variable code that controls the relay.
 The Pre-alarm value.
 The minimum value below which the relay is activated.
 The maximum value above which the relay is activated.
 The delay in connecting and disconnecting the relay.
 The status of the outputs.
 The latch.
figure 129: Configuration screen of relay digital outputs.
The parameter selected is indicated in white.
The following options appear in the lower area:
● When programming the variable code which controls the relay digital output ( Table 21 ):
, ... The ten possible digits to program �
Delete character, deletes the selected character �
Delete parameter, deletes the characters of the selected parameter.
Previous, selects the previous parameter �
Next, selects the next parameter �
Confirm, confirms and saves in the memory the values programmed on the screen �
Back, returns to the home screen of the setup menu figure 113 .
Main Menu, back to the main menu, figure 25 .
Use the keys and to select the different options.
To confirm the selection, press the key .
145 Instruction Manual
CVM-B100 - CVM-B150