CIRCUTOR CVM-B Series User Manual
Page 148
(1)
The integrated variables are those that the unit has as standard.
(2)
If in the unit there is more than one module connected with the same type of inputs, the module with the lowest
number is the one with the lowest serial number.
(3)
When programming as an alarm a digital input programmed as logic state if:
- You program the maximum value = minimum value = 0 the output will show an alarm when the input has
a value of 1.
- You program the maximum value = minimum value = 1 the output will show an alarm when the input has
a value of 0.
Any other combination of values will cause erroneous behaviour of the alarm.
The pre-alarm value is not considered.
(4)
Codes valid only for programming the digital outputs of the transistor in impulse mode.
(5)
Codes not valid for programming analogue outputs.
● When programming the
pre-alarm value:
If the unit exceeds the programmed pre-alarm value, the icon
is activated on the display,
and the icon that indicates the alarm status changes colour:
.
The value is programmed in %.
,
...
The ten possible digits to program
�
Delete character, deletes the selected character
�
Delete parameter, deletes the characters of the selected parameter.
Previous, selects the previous parameter
�
Next, selects the next parameter
�
Confirm, confirms and saves in the memory the values programmed on the screen
�
Back, returns to the home screen of the setup menu
.
Main Menu, back to the main menu,
figure 25
.
Use the keys
and
to select the different options.
To confirm the selection, press the key
.
If no key is pressed for 5 minutes, the display screen changes automatically to the default
screen, which displays the voltage measurement of 4 parameters.
● When programming the
minimum value below which the relay is activated:
The units and maximum and minimum values of the variables to program are shown in
Table 22
.
,
...
,
,
The ten possible digits to program
�
Delete character, deletes the selected character
�
Delete parameter, deletes the characters of the selected parameter.
Previous, selects the previous parameter
�
Next, selects the next parameter
�
148
CVM-B100 - CVM-B150
Instruction Manual