Toa SX-2000 Series User Manual
Page 86
86
PATTERN SETTINGS
Failure Output Pattern Settings
(6) Copy and Paste buttons
Pressing the [Copy] button copies all of the on-screen settings except the name preset by default.
Pressing the [Paste] button pastes the copied parameters in the same setting screen of other failure output
pattern selected by Number (1).
(5) Failure status output
Set the control output pattern to be output when the set failure output pattern has occurred.
This setting item is valid when at least one surveillance target point is selected in the item (3).
None (default), Set control output patterns
Available Settings
(4) External failure input
This function is available when the
"External failure input" (p. 97)
is set to the control input terminals of the
SX-2000SM, SX-2100AI, SX-2000AO, SX-2100AO, and SX-2000CI.
Note
Use the Event of each unit in the "Event Settings" to set the function to the control input terminals.
For details, refer to
None (default), External failure input terminals set in the "Event Settings."
Available Settings
(2) Name
Enter the names of the failure output pattern.
(3) Failure detection units or surveillance target points settings
Select the units or surveillance target points as factors to activate failure
output patterns.
Tip
For quick selection of multiple cells, refer to
Colored (Selected), Colorless (Not selected, default)
Available Settings
Up to 32 alphanumeric characters. (default: Failure output pattern 1 – 256)
Available Settings
[When selected]
(1) Number
Click on the box or press the arrow button to select the failure output pattern number.
1 to 256 (default: 1)
Available Settings
any one of the units within the system.
Determine the method to activate the failure output patterns using the
Each setting button on the screen represents the surveillance points as shown below.
DC POWER: DC power of the SX-2000SM, SX-2000AI, SX-2100AI, SX-2000AO, SX-2100AO, SX-2000CI,
or SX-2000CO
DC FUSE*:
Fuse inside the amplifier connected to the SX-2100AO
DS LINK:
DS link of the SX-2000SM and SX-2100AO
SX LINK:
SX link of the SX-2000SM, SX-2000AI, SX-2100AI, SX-2000AO, and SX-2100AO
RM LINK:
RM link of the remote microphone connected to the SX-2000AI or SX-2100AI
* DC FUSE setting button becomes active when the "Amplifier" checkbox is marked in the