Toa SX-2000 Series - Manual (Page 141)

141
UTILITY
System Status Display Confirmation (AO unit screen)
13.3.4. AO unit screen
Clicking the AO button on the system status screen displays the AO unit screen.
1
2
3
6
10
7
9
4
5
8
11
12
1. Unit configuration
• Link
Displays the SX-2000AO or SX-2100AO system status.
Configuration Displays connection setting information.
• Set:
Connection settings performed.
• None: No connection settings performed.
Current Displays actual connection status.
• Connect:
The SX-2000AO or SX-2100AO is connected.
• Disconnect: The SX-2000AO or SX-2100AO is not connected.
Status Displays whether the SX-2000AO or SX-2100AO can communicate with and system
control can be performed from the SX-2000SM.
• Link:
The SX-2000AO or SX-2100AO can communicate with the
SX-2000SM and system control can be performed from the
SX-2000SM.
• Unlink: SX-2000SM communications not available, since the SX-
2000AO or SX-2100AO is not connected or powered.
• Emergency cutoff: Since the corresponding SX-2000AO unit is preset to cut off
the 24V DC power supply to allow emergency broadcast to go
through, the SX-2000SM cannot perform control.
• Mismatch version: SX-2000AO or SX-2100AO and SX-2000SM versions
incompatible, disabling communications.
Note
The Link indication is displayed in red if errors
are shown in "Current" or "Status."