Toa SX-2000 Series - Manual (Page 115)

115
EVENT SETTINGS
RM Event Settings (RM-200SF)
[If "General EV message start/end" is selected for "Function" ]
(3) Contents (left side)
Select the general EV message to be activated with RM-200SF or RM-210 key operation.
Use the "System settings
SX-2000SM" ( p. 46 "Registering sound sources" ) to register the general EV
message.
Settings cannot be performed unless the general EV message has been registered.
[If "RM broadcast status" is selected for "Function" ]
(3) Contents (left side)
Set the RM-200SF or RM-210 remote microphone function keys to select which remote microphone
broadcast conditions to monitor. When a broadcast is in progress at the selected remote microphone, the
broadcast status indicator corresponding to the function key lights.
(4) Contents (right side)
Select the control output that operates in synchronization with the keys on the RM-200SF or RM-210.
Set the control output pattern using
"Pattern settings Control output pattern settings" (p. 81) .
None (default), Set control output pattern Available Settings
[If "BGM pattern change/end" is selected for "Function" ]
(3) Contents (left side)
Select the BGM broadcast pattern to be assigned to the keys on the RM-200SF or RM-210.
Set the BGM pattern using
"Pattern settings BGM pattern settings" (p. 78) .
If the broadcast pattern is set to "End," then it is not possible to set "Control output pattern" (next item).
End (default), Set BGM broadcast pattern Available Settings
[If "Emergency broadcast pattern start" is selected for "Function" ]
(3) Contents (left side)
Select the emergency broadcast pattern to be activated by the keys on the RM-200SF or RM-210.
Set the emergency broadcast pattern using
"Pattern settings Emergency broadcast pattern settings"
(p. 83) .
None (default), Set emergency broadcast pattern Available Settings
[If "Emergency broadcast pattern stop" is selected for "Function" ]
(3) Contents (left side)
Select the emergency broadcast pattern to be stopped by the keys on the RM-200SF or RM-210.
Set the emergency broadcast pattern using
"Pattern settings Emergency broadcast pattern settings"
(p. 83) .
Set emergency broadcast pattern (default: Pattern 1) Available Settings
Set general EV message (Default: the lowest sound source number message of
all set general EV messages) Available Settings
Set remote microphone (Default: the lowest unit number remote microphone
connected to the lowest unit number SX-2000AI or SX-2100AI). Available Settings