Ecler ECLERNET MANAGER - Manual (Page 96)

96
 Add New Remote: to manually add a WPTOUCH (digital), MPAGE16 (digital) or ANALOG
(WPVOL-SR type) remote control to the REMOTE LIST
 Remove Remote: to remove one of the devices from the REMOTE LIST
 Change Remote Name: to change the name of a remote control from the REMOTE LIST
The digital remote controls have a status icon located to the right of their name and model in the list
(green for the "ZONE1" remote control in the picture):
This icon lights up differently to indicate distinct states:
 Unlit: the virtual remote control (from list) is not associated with any hardware device
 Steady red: the hardware device associated with the virtual remote control panel is not "online"
(the MIMO88 unit it depends on is disconnected)
 Flashing red: the hardware device associated with the virtual remote control panel has been
detected "online" by the MIMO88 (the MIMO88 unit it depends on is connected, but the remote
control is disconnected)
 Steady green: both MIMO88 hardware and the remote control are "online" and operational
 Flashing green: the operating MIMO88 and the remote control are "online" but not operational
(firmware-software versions are not compatible)