Ecler ECLERNET MANAGER - Manual (Page 177)

177
10.3. Functions assignment in the UCP
When controls are placed on the surface of the page, you need to assign them a parameter and a
hardware unit to remotely control. To do this, select one of the controls and in the properties window
click on the
Param property:
Then a browser window (Select Parameter) opens to select a hardware unit of the project and, within it,
a parameter to control. Continuing the example above, the fader that is now displayed with its new
appearance (large, white) will control OUT2 volume in a device called "matrix" (in this case a MIMO88).
Selectable hardware devices are all MIMO88s, NZAs or NPAs that were previously included in the
project. Thus, a single UCP can have a global control over all hardware devices of the installation (inputs
volume and mute, outputs and/or groups of inputs or outputs, presets recall, sending messages to
destination areas, etc..), so that the user manages the installation as a single global entity from a single
control panel, without taking care of the number, the location and the connection of hardware units that
are really working.
In the following example we see a project that includes 5 MIMO88 units, called matrix, Lecture th. #1,
Lecture th. #2, EVAC SYSTEM and OUTDOOR areas, that might have some of their parameters linked
to virtual controls in our UCPs: