Ecler ECLERNET MANAGER - Manual (Page 52)

52
Counter for the number of times the device protection alarm has been triggered
Heat sink internal temperature meter (in % of alarm triggering threshold)
Counter for the number of times the device temperature alarm has been triggered
Load impedance at the device terminals (1)
Counter for the number of times the device load impedance alarm has been
triggered
RMS power meter at the channel output terminals
Peak power meter at the channel output terminals
RMS voltage meter at the channel output terminals
Peak voltage meter at the channel output terminals
Channel configuration. See (2)
(1) The real time measurement of load impedance and the activation of the relevant alarm are affected
by the functional state of hardware and the installation cabling load (in case of crossing or open circuit in
a speaker line, faulty amplifier, etc.), as well as by some audio program and volume transients produced
over the time.
This may generate occasional measurement inaccuracies, leading to a false alarm triggering:
It is important to note that the load impedance alarm triggering can be due to a
combination of temporary factors which are not abnormal in the installation. Check after
triggering if the triggering condition is maintained over time, i.e. whether it is a false alarm
or a true one requiring maintenance.
(2) Channel configuration.
Clicking on the configuration edit icon opens the parameter setting window: