Ecler ECLERNET MANAGER - Manual (Page 108)

108
7.10.1.2. Configuring the WPTOUCH for operating with a carousel of inputs
A carousel list of inputs allows you to select which input will feed a particular output from a WPTOUCH
acting as a selector of music sources for a destination zone (input selector for the matrix outputs). There
may be up to 16 WPTOUCH units in one MIMO88 system (8x8 or 16x16), each one with the ability to
select the audio content for the zone it is assigned to. See section: 7.11 Carousel lists for MIMO88 for
more information about the creation of carousel lists.
Selecting CAROUSEL in the SELECTOR function opens a menu to select the desired carousel list.
Selecting a carousel list of inputs opens a new menu that lets you decide which system output will be
linked to the input selection or in other words what destination zone (output) is controlled by this
WPTOUCH unit:
In the example we have selected a carousel list of inputs (called INPUTS WP#2) to enable input
selection in this list for Output 3. This WPTOUCH unit will then behave as a sound source selector for
the Zone 3 of the system.
After selecting a carousel list of inputs for the Selection mode of a WPTOUCH, you can make the
selection from the WPTOUCH unit as follows:
 pressing T2 switches to the Selection mode (the triangular icon to the right of the LCD
screen moves up to the upper row)
 with the wheel, select one of the inputs contained in the carousel list
 pressing T2 again confirms the selection, the matrix is set to route the selected input to
the assigned output and the triangular icon returns on the bottom row (back in Volume
Mode)
The following configuration function (VOLUME) lets you select which volume the WPTOUCH wheel
controls in the other mode, the Volume mode (when the triangle is by default on the right of the bottom
row of the LCD).