Ecler ECLERNET MANAGER - Manual (Page 137)

137
 MATRIX MUTE: to MUTE a matrix crossing point; you need to select this crossing point and its
behaviour mode:
o PUSH: "unlatch" mode; MUTE control follows the stimulus (for example, MUTE ON as
long as the switch is pressed)
o TOGGLE: "latch" mode; successive presses toggle the MUTE on/off
 GPO: to enable/disable a GPO port of the MIMO88 unit; you need to select this port and its
behaviour mode:
o PUSH: "unlatch" mode; the GPO follows the stimulus (for example, GPO ON as long as
the switch is pressed)
o TOGGLE: "latch" mode; successive presses toggle the GPO on/off
 PRESET: Preset recall from the MIMO88 memory by selection in the list of available Presets:
Note: It is important to understand that a Preset is restored only when there is a rising edge
as a stimulus. In the case of a simple digital event, if it is designed to recall a Preset, you
must be sure that there will be a rising edge (0 to 1) as a stimulus, whatever the input type
(GPI, UCP button)