Ecler ECLERNET MANAGER - Manual (Page 60)

60
6.6. DELAY
The DELAY section allows you to set an independent delay time for each channel,
which is applied between input and output.
The delay time can be specified in different units, selected with UNITS parameter.
Available units are milliseconds, seconds, centimeters and meters. DELAY can be
set between 0 and 1000 milliseconds.
To avoid weird and annoying noises in the output signal, the value change made with the DELAY
potentiometer is not effective until the mouse button is released. At that time audio will be temporarily
muted (for a variable time, depending on the delay value used) for the new setting to be effective.
6.7. Copying and pasting settings between channels
Copy Channel Data and Paste Channel Data icons ( ), located in the upper right corner of the
control panel of each device channel, are used to copy all settings from one amplification channel in a
temporary memory and paste them in another amplification channel.
Considerations:
 Channel copying and pasting can be done within a single device or from a device channel to a
channel of another device
 In the latter case, copying and pasting operation can only be made between channels of the
same device series (you cannot copy a channel from a NPA amplifier and paste it into a NZA
amplifier, or vice versa)
 To clone the full configuration of all channels from one device to another, use Copy Device
Preset and Paste Device Preset from the icons to the right of the preset name in the upper
section of the device configuration