KEYENCE LS-5000 - Manual (Page 42)

Chapter 6 Normal Mode
36
6
5 5 5 5 5 [CALIB] Calibration Setup
Minute measurement fluctuations caused by a change in the target surface condi-
tion or target inclination can be corrected with each AREA. (
➮ See p.39 for setting
AREA.)
■ Setting Procedure
1. Select the CALIBRATE AREA screen.
Press the [CALIB] button. The screen shown below is displayed.
2. Press the button corresponding to the area for which you wish to perform
calibration.
Press the [RESET] button to reset the calibration. The calibration value is reset
to the factory setting.
Press the [CALIBRATE] button to go to the CALIBRATE screen.
3. Insert sample workpiece 1 to check the measured value.
Enter the value of sample workpiece 1 using the numeric keys, and accept the
value by pressing the [ENTER] button.
AREA1 CALIB • • • AREA4
CALIBRATE AREA2 LASER ON NOR
MAL
P. 1
DATA 54.21595
ESC
CALIBRATE
RESET
LASER ON CALIBRATE AREA NOR
MAL
P. 1
DISPLAY
DATA
LIMIT
SETUP
PROGRAM CALIB OPTIONS
AREA1
AREA2
AREA3
AREA4
Select Segment No. to calibrate.
CALIBRATE AREA1 LASER ON NOR
MAL
P. 1
8 7
5 6 4
2 3 1
. 0
9
ENTER
CANCEL
ESCAPE
TARGET1 0.0000
DATA 54.21595
TARGET1 0.0000
Enter calibration
values for targets
1 and 2, and press
OK.
OK