KEYENCE LS-5000 - Manual (Page 103)

Chapter 8 RS-232C I/O
97
8
8.3 Command List
This section lists all commands and describes each code.
1. Upper line: Character code, Lower line: ASCII code
Note: When the LS-5000 series receives a command other than those listed
above, it sends back the “ERRORCR” message ([E][R][R][O][R][CR]).
Function Command received 1. Description
[M][#][CR] (#:0 to 4) Send a measured value once.
4DH#0DH
[N][#][CR] (#:0 to 4) Send a measured value continuously.
4EH#0DH
[O][CR] Stop continuous transmission of
4FH 0DH meas ured value.
[T][#][CR] (#:0 to 4) Turns ON the synchronous input.
54H#0DH
[U][#][CR] (#:0 to 4) Turns OFF the synchronous input.
55H#0DH
[Q][#][CR] (#:0 to 4) Reset input.
51H#0DH
[V][#][CR] (#:0 to 4) Auto-zero input.
56H#0DH
[W][#][CR] (#:0 to 4) Resets the auto-zero input.
57H#0DH
[P][#][#][CR] (##:01 to 16) Program number is changed.
50H##0DH
[S][R][CR] Read preset data.
53H 52H 0DH
[S][W] ... [CR] Write preset data.
53H 57H ...0DH
Output of
measured value
Timing
Reset
Auto-zero
Program No.
Selection
Reading preset
data
Writing preset data